Denali Electronics T3 Modular Switchback Signal CANSmart Wiring Harness

Use the Denali wiring adapter for connecting T3 Switchback turn signals to the GEN II CANsmart Controller for a true plug-n-play connection.

Compatible with all Denali GEN II CANsmart Controllers, no wire tapping or other modifications are necessary, just plug directly into the circuits of the CANsmart to send the signals from your controller to the T3 Lights. This harness is designed to power a set of four T3 lights; two rear T3s and two front T3s, but can also be configured for an installation of just front or rear T3s as well.

Please note that when powering rear T3s through this plug-n-play adapter from a CANsmart, the red running light will remain illuminated between the amber turn signal flashing. This is an unavoidable result when powering T3s solely from a CANsmart. If you'd prefer that the running light shuts off when the amber signal is active, simply connect the red running light wires from the T3 pods directly to a switched power source on your vehicle (and set the CANsmart brake light circuit to brake only).